|
T.R.
Jones Die Components
Manufactured exclusively by
Marquardt & Mueller Machining, Inc.
Phone: 815-334-5974
Fax: 815-334-5978
|
Return
|
|
Subliner
Pins |
|
 |
| Subliner
Pins provide exact alignment of the punch holder,
stripper plate and die bock. As the die is closing, the
bullet nose of the Subliner enters a precision slip fit
hole in the die block. Since the Subliner is pressed
into the stripper plate, and is a precision slip fit in
the punch holder, accurate alignment is accomplished.
Optional Flats on the shoulder help prevent turning when
the screw is inserted or removed.
How many are
required?
- For maximum alignment
and parallelism, a minimum of four Subliner Pins
should be used for each stripper section in the die.
This will minimize stripper deflection.
- For precision
alignment only, two Subliner Pins and two Balancer
Pins are required to produce the correct stripping
action for each spring stripper section of the die.
|
|
Advantages
- Eliminates need for
stripper bolts and are commonly used to support the
die spring.
- Assures parallel
alignment of the stripper plate and the die block
when the shoulder of Subliner / Balancer extends
.003/.005 less than the stock thickness.
- Aligns delicate and
close-fitting punches with stripper plate.
- All critical diameters
ground +/- .0002 and concentric +/- .0002 TIR.
Shoulder thickness +/-.001 and length +/-.002.
- Made of SAE-O6 tool
steel, through hardened 58-61 RC.
- Available in standard
sizes for greater savings and quicker
delivery.
- Made to customer
specifications, (Metric or English).
|
|
|